Slant Six Forum https://slantsix.org/forum/ |
|
Source for Exhaust Flange https://slantsix.org/forum/viewtopic.php?t=40396 |
Page 1 of 1 |
Author: | fzmax [ Wed May 26, 2010 7:38 pm ] |
Post subject: | Source for Exhaust Flange |
I'm looking for a flange to bolt to the exhaust manifold. It shouldn't be this hard, but after scouring the interweb for hours I can't find one. I can make my own, but figure a hole saw will cost the same as a flange. any leads would be appreciated. |
Author: | lowbudget [ Wed May 26, 2010 9:33 pm ] |
Post subject: | |
I might be wrong but isn't it just a mopar flange, small block? The gasket fits all kinds of stuff. Thanks Mike |
Author: | Fopar [ Wed May 26, 2010 9:41 pm ] |
Post subject: | |
Try a muffler shop, they have a good assortment of sizes. |
Author: | Dart270 [ Thu May 27, 2010 6:12 am ] |
Post subject: | |
They have always had those at exh shops, in stock. Very standard size. Lou |
Page 1 of 1 | All times are UTC-08:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |