I have just been given an Offenhauser #5041 Dual Single-Barrel Manifold.
My question is-

Does anybody know where I can go to find a linkage for this set-up? Or is this a fabricate it yourself project?

If anyone can direct me in the right direction I would be grateful!

Rennie

The Offenhauser #5041K linkage kit helps adapt the pre-'67 rod-type throttle linkage to operate the dual 1bbls. If you're installing on a car with cable-operated throttle (all '67-up cars plus '65-'66 A-bodies with factory A/C and '62-up B-bodies), then creating workable throttle and kickdown linkage is a "you're-on-your-own" situation. See also here annd here.

_________________
一期一会
Too many people who were born on third base actually believe they've hit a triple.

Hey, Renko......Wanna double your money?

Roger

should the vacum advance come from 1 carb or two i have mine set to the two but getting a miss around 2500 rpm runs great at idle

Try taking the vacuum advance from one carb (plug off the other) and see if the miss goes away.

(can't identify those carbs you're using there...change those small air cleaners early and often! )

_________________
一期一会
Too many people who were born on third base actually believe they've hit a triple.

carter 1 barrels