| Slant Six Forum https://slantsix.org/forum/ |
|
| turbo slant help https://slantsix.org/forum/viewtopic.php?t=4054 |
Page 1 of 1 |
| Author: | ernesto felix [ Thu Aug 15, 2002 10:21 am ] |
| Post subject: | turbo slant help |
hello slant guys: i am trying to build a blowthru slants 6 (225cid)here in mexico but i want to set the engine with the stock crank and rods, but i`m using the 2.2L turbo pistons because i read that they are better to stand the heat than the 225 stock piston. my problem is that the 2.2l piston is a bit shorter thant the 225 and that makes my CR too low, but i though that is i put a 198 road the CR incrises. the big problem is the 198 engine wasent buid in mexico. I was wondering is any of you guys have a spare set of 198 rod for sale and how much would they cost to ship them here. ernestoft74@yahoo.com.mx |
|
| Author: | Al T [ Sat Aug 17, 2002 9:41 pm ] |
| Post subject: | Re: turbo slant help |
Did you find the rods you were looking for? ahtoews@shaw.ca |
|
| Author: | ernesto felix [ Sun Aug 18, 2002 10:42 am ] |
| Post subject: | Re: turbo slant help |
Quote:
: Did you find the rods you were looking for?
No i did not. I milled the blok .100 inch. but I have another project in mind that could use the 198 rod. do you have a set? ernestoft74@yahoo.com.mx |
|
| Author: | Doctor Dodge (Doug Dutra) [ Sun Aug 18, 2002 10:59 am ] |
| Post subject: | Re: 198 connecting rods |
Quote:
: No i did not. I milled the blok .100 inch. but : I have another project in mind that could : use the 198 rod. do you have a set? There is a set of 198 con rods selling on ebay now and a source for them listed in our parts data base. DD |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|