Thanks Josh, and I understand. Mine is a gas tank. No bladder.
Rick
| Slant Six Forum https://slantsix.org/forum/ |
|
| Fuel Cell https://slantsix.org/forum/viewtopic.php?t=41258 |
Page 1 of 1 |
| Author: | Rick Covalt [ Fri Jul 30, 2010 8:06 am ] |
| Post subject: | Fuel Cell |
I have my fuel cell mounted in the car now. But I need some guidance on the venting. My cell has an outlet on the bottom and 2 fittings on the top. Are these both vents? Can they be tied together? And any special routing needed on the vent lines? Thanks in advance, Rick |
|
| Author: | Will [ Fri Jul 30, 2010 4:03 pm ] |
| Post subject: | |
one is the return line for efi, that would be the one with the line going down into the foam. Just cap it off. Will |
|
| Author: | Rick Covalt [ Fri Jul 30, 2010 8:05 pm ] |
| Post subject: | Thanks |
Ok Thanks Will. I sent you a PM too. Rick |
|
| Author: | Rick Covalt [ Thu Aug 12, 2010 1:56 pm ] |
| Post subject: | Is foam needed ? |
Do I need to have foam in the tank? Mine does not have any. Rick |
|
| Author: | Joshie225 [ Thu Aug 12, 2010 2:24 pm ] |
| Post subject: | |
Foam helps to reduce slosh and arrest fire, but it's not essential unless the track rules make it a requirement. To me, and many sanctioning bodies, a fuel cell has a flexible bladder inside a metal can. The metal can can be punctured and not spill any fuel. Without the bladder it's just a fuel tank. |
|
| Author: | Rick Covalt [ Thu Aug 12, 2010 4:19 pm ] |
| Post subject: | THanks Josh |
Thanks Josh, and I understand. Mine is a gas tank. No bladder. Rick |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|