You have to line the 2 marks up through the centre of both cogs,should have a diagram that comes with your new timing chain set or try to get hold of a workshop manual they show you what to do.
| Slant Six Forum https://slantsix.org/forum/ |
|
| 225 timing change replacement https://slantsix.org/forum/viewtopic.php?t=41349 |
Page 1 of 1 |
| Author: | daddanjer [ Sat Aug 07, 2010 8:11 pm ] |
| Post subject: | 225 timing change replacement |
Hello , I am in process of replacing the timing chain set on our 1966 Dart. Motor is 225cid. The original timing chain jumped a tooth and I am trying to line up gears from new set. The Set I bought did not specify. Can someone let me know what marks are to be lined up. I see a dot on cam gear and a dot on Crank gear and figure these are the two to line up. Is this correct? I don't want to make a mistake as this is first time I have changed a timing set. Does the key have any bearing on the location that marks should be in? Thank you for your help. Ed |
|
| Author: | bigall [ Sun Aug 08, 2010 2:05 am ] |
| Post subject: | 225 timing chain replacement. |
You have to line the 2 marks up through the centre of both cogs,should have a diagram that comes with your new timing chain set or try to get hold of a workshop manual they show you what to do.
|
|
| Author: | dakight [ Sun Aug 08, 2010 5:25 am ] |
| Post subject: | |
Lining up the marks will get it run. However, due to variations in manufacture of the gears and the crank and cam, you will get best results if you use a degree wheel and set it up according to specs. |
|
| Author: | daddanjer [ Sun Aug 08, 2010 6:41 am ] |
| Post subject: | |
Thanks for info. Will have her back on the road today. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|