Slant Six Forum
https://slantsix.org/forum/

Intake/Exhaust stud specs?
https://slantsix.org/forum/viewtopic.php?t=41844		 Page 1 of 1
Author:  Porter [ Fri Sep 10, 2010 8:30 am ]
Post subject:  Intake/Exhaust stud specs?
I sent my head to a shop to get reconditioned and they had to remove my intake and exhaust manifold studs to fit the seat and guide machine. When I went to pick it up, the studs had been pitched. I know I can get these studs included in the ARP head stud kit, but I don't want to use head studs. I just want to know the lengh of the studs and how much thread is on each side of the shank.

Any help would be appreciated.

Thanks,

John
Author:  Wesola78 [ Fri Sep 17, 2010 4:22 am ]
Post subject: 
I'm not sure, but the last time I replaced the intake/exhaust manifold gasket, the studs looked to be sticking out about an inch and a half, more or less. On the threads, I would guess that they go from the tip of the stud almost to the head.
Author:  Wesola78 [ Fri Sep 17, 2010 4:23 am ]
Post subject: 
Oh yeah, I read here somewhere that carb studs are the same as slant six intake/exhaust manifold studs.
Author:  66aCUDA [ Fri Sep 17, 2010 8:08 am ]
Post subject: 
Reed had this same question about a month ago. See if he found a solution.
Frank
Author:  Doc [ Fri Sep 17, 2010 12:38 pm ]
Post subject: 
Manifold set to Cylinder Head Studs are 5/16-18 unc x 1/2" thread length (head side) by 5/16-24 unf x 3/4" manifold side.
The factory stud was 1 7/8" in total length so there was about 5/8 inch of unthreaded area between the two threaded ends.

Many of today's replacement "aftermarket" studs are either a little long (2 inch total) or a little short. (1 3/4" total) The thickness of the "spanner washers" to be used, will help decide on which stud to get.
The machine shop that "tossed" yours, should get you a set of replacements.
DD

Image
Author:  Porter [ Sun Sep 19, 2010 10:46 am ]
Post subject: 
Thanks,

I found a set specifically for slant six manifolds at www.silver-seal.com. 1.88 inches long... PN 6403... 8 bucks.
Author:  slantzilla [ Wed Sep 22, 2010 2:58 pm ]
Post subject: 
Quote:
Thanks,

I found a set specifically for slant six manifolds at www.silver-seal.com. 1.88 inches long... PN 6403... 8 bucks.
I just tried to order through their website and couldn't. Called the toll free number and the lady said I was her 5th complaint today. I just ordered over the phone. 36 studs @ .50 each. :D

Thanks for the link! 8)
Author:  Porter [ Fri Sep 24, 2010 4:59 am ]
Post subject: 
You are very welcome!
Author:  slantzilla [ Sun Sep 26, 2010 8:30 am ]
Post subject: 
Studs were in the mail yesterday. I would call that great service. :D
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/