Slant Six Forum
https://slantsix.org/forum/

more parts found
https://slantsix.org/forum/viewtopic.php?t=42431
Page 1 of 1

Author:  shadetree [ Thu Oct 28, 2010 10:43 am ]
Post subject:  more parts found

Ok napa has some 1/4 studs all coarse thread and
an inch and a 1/4 long. Great for studding valve covers
or oil pans. Also they have a really cool coupling nut
1/4 coarse thread but its only 3/8 hex. Also have found
wire spiral loom in fifty and twenty foot lenghts made by
Grote.

lol Shadetree

Author:  olafla [ Thu Oct 28, 2010 11:03 am ]
Post subject: 

Hi shadetree, have you got a part number? I

if you want to link to a page on a website, you do it by writing: [url=a-copy-of-the-site-name]your-comment-or-name-of the-site[/url]

Olaf.

Author:  Joshie225 [ Thu Oct 28, 2010 12:23 pm ]
Post subject: 

If you want coarse thread valve cover studs you can just use 1/4" set screws and LockTite them in place. When I put in studs for my V8's valve covers I used regular coarse/fine studs with fine threaded nuts. Portland has an excellent hardware store Parkrose Hardware. It's superior to any other hardware store I've found for fasteners.

Author:  GTS225 [ Fri Oct 29, 2010 10:05 am ]
Post subject: 

Any auto parts outlet that carries the "Dorman" line, or fastener supply that caters to the commercial/industrial market should be able to fix you up with just about any stud you might want.

Roger

Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/