Kevin that isn't going to work the lifters are much larger than the push rod holes in the head.
:tsk: 
Richard
| Slant Six Forum https://slantsix.org/forum/ |
|
| What year? https://slantsix.org/forum/viewtopic.php?t=42486 |
Page 1 of 1 |
| Author: | marineviper [ Wed Nov 03, 2010 7:55 pm ] |
| Post subject: | What year? |
What year did the head change so you have to remove it to get the lifter out??? I have an 80. |
|
| Author: | Joshie225 [ Wed Nov 03, 2010 8:08 pm ] |
| Post subject: | |
The head changed in '75. The loss of spark plug tubes meat the loss of easy access to the lifters. |
|
| Author: | kesteb [ Wed Nov 03, 2010 10:56 pm ] |
| Post subject: | |
Not so, you should be able to remove the lifters without removing the head with a '80 or later head. |
|
| Author: | Fopar [ Thu Nov 04, 2010 12:03 am ] |
| Post subject: | |
Kevin that isn't going to work the lifters are much larger than the push rod holes in the head. :tsk: Richard |
|
| Author: | Dart270 [ Thu Nov 04, 2010 8:11 am ] |
| Post subject: | |
I believe '81 was the latest (hydro) head with larger pushrod holes, just bigger than lifters. '76-81 was one with small pushrod holes and no drool tubes. Lou |
|
| Author: | kesteb [ Fri Nov 05, 2010 11:33 pm ] |
| Post subject: | |
I have an '80 head seating on the floor that you can slip the lifters thru. The '79 head that is currently on my engine you can not. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|