Slant Six Forum
https://slantsix.org/forum/

Dutra Duals
https://slantsix.org/forum/viewtopic.php?t=42669		 Page 1 of 1
Author:  grthigpen [ Tue Nov 23, 2010 4:18 pm ]
Post subject:  Dutra Duals
need a pair tks
Author:  Doc [ Tue Nov 23, 2010 4:31 pm ]
Post subject: 
PM sent.
DD
Author:  coconuteater64 [ Tue Nov 23, 2010 8:28 pm ]
Post subject: 
You'll love them!
Author:  64drtGt [ Wed Nov 24, 2010 5:50 am ]
Post subject: 
I want me a set but I'm a poor 18 yo with no job so I'm gonna make my own and see how they come out.
Author:  coconuteater64 [ Wed Nov 24, 2010 12:55 pm ]
Post subject: 
Quote:
I want me a set but I'm a poor 18 yo with no job so I'm gonna make my own and see how they come out.
By the time you saw, measure, cut, heat, grind, weld, cuss, and redo it a couple times, you could just rake leaves or snow for the neighbors and save up enough for a set. maybe Santa can kick in a few bucks. Certainly it's do-able, but why go to all the trouble?
A Dutra set has cut out all the guesswork. Mine fit as if Chrysler had made them... right out of the box.
Author:  Tim Keith [ Wed Nov 24, 2010 5:57 pm ]
Post subject: 
This is off topic but how good are these with a turbo, or maybe two small turbos? I might be interested in building a turbo 225 and like a clean looking exhaust set up that is not too cluttered ( especially around the starter). I appreciate the work that Doug has done.
Author:  luigisir [ Thu Nov 25, 2010 7:42 am ]
Post subject:  out of curiosity
how much is a pair?
Author:  Doctor Dodge [ Thu Nov 25, 2010 11:39 am ]
Post subject: 
Pricing starts at $250.00 for a single Dutra casting, ready to install...
The cost of the rear manifold is based on what you do... either modify a factory exhaust manifold or use another new Dutra casting, machined to fit the rear 3 cylinders. (Dual Dutra Duals)
DD
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/