The square "shoulder" faces the bearing.
If it looks like this you are OK.
DD
| Slant Six Forum https://slantsix.org/forum/ |
|
| puzzled https://slantsix.org/forum/viewtopic.php?t=43526 |
Page 1 of 1 |
| Author: | moparguru [ Fri Feb 04, 2011 4:20 pm ] |
| Post subject: | puzzled |
when putting in the rear main seal the slant six forum article says to put the sloped edge outward but the seal package felpro 40240 says put the sloped edge to the inside what is the right way please help my engine has a rope seal so i have nothing for reference |
|
| Author: | Fopar [ Fri Feb 04, 2011 4:52 pm ] |
| Post subject: | |
See this for what you are asking about. http://www.slantsix.org/articles/gasket ... n-seal.htm Richard |
|
| Author: | Doc [ Fri Feb 04, 2011 5:10 pm ] |
| Post subject: | |
The square "shoulder" faces the bearing. If it looks like this you are OK. DD
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|