I know the one in my '66 Valiant with single master worked when I converted it to dual master. Shouldn't be a whole lot of difference in them.
| Slant Six Forum https://slantsix.org/forum/ |
|
| MAster cylinder push rod https://slantsix.org/forum/viewtopic.php?t=45548 |
Page 1 of 1 |
| Author: | bbbbbb9 [ Thu Jul 07, 2011 6:41 am ] |
| Post subject: | MAster cylinder push rod |
Does anyone know what master cylinder push rods work with a dual master from a 74 Duster with disc brakes? In other words do they interchange and what are the interchange years/models? I've lost mine and am looking for a replacement. Thanks |
|
| Author: | slantzilla [ Thu Jul 14, 2011 2:13 pm ] |
| Post subject: | |
I know the one in my '66 Valiant with single master worked when I converted it to dual master. Shouldn't be a whole lot of difference in them.
|
|
| Author: | Doc [ Thu Jul 14, 2011 3:57 pm ] |
| Post subject: | |
2X - I think they are all the same for the 60-76 A-Body Mopars. (I have a few extras if you need 1) DD |
|
| Author: | DusterIdiot [ Thu Jul 14, 2011 6:35 pm ] |
| Post subject: | x3 |
Quote: 2X - I think they are all the same for the 60-76 A-Body Mopars.
x3...And I know that you can bolt a '65 Barracuda single pot and pushrod into a '64 imperial in an emergency (don't expect to stop on the dollar though!!!)
|
|
| Author: | ESP47 [ Fri Jul 15, 2011 12:23 pm ] |
| Post subject: | |
Do power brake pushrods interchange with manual brake pushrods? |
|
| Author: | kesteb [ Sat Jul 16, 2011 8:44 am ] |
| Post subject: | |
No |
|
| Author: | MotoGrey [ Sat Jul 16, 2011 11:15 am ] |
| Post subject: | Brake light switch |
I just upgraded the M/C on a 62 Lancer and now the brake light switch is not making contact with the pedal shaft. 3/4 inch too short. Anyone know what is up with that? |
|
| Author: | bbbbbb9 [ Mon Jul 18, 2011 8:29 am ] |
| Post subject: | |
DOC, pm sent |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|