| Slant Six Forum https://slantsix.org/forum/ |
|
| Gasket question https://slantsix.org/forum/viewtopic.php?t=45984 |
Page 1 of 1 |
| Author: | racinkain [ Tue Aug 16, 2011 7:34 pm ] |
| Post subject: | Gasket question |
Is there a preferred brand intake/Exhaust gasket? part #? Getting ready to change to Aluminum intake and headers soon. |
|
| Author: | Doc [ Wed Aug 17, 2011 8:48 am ] |
| Post subject: | |
Have you read the installation article? http://www.slantsix.org/articles/Slant_ ... lation.htm For me... the "best gasket" is really a good resurfacing job on the manifold set. I have set-up countless SL6 manifold assemblies and they always need to be resurfaced to get them completly flat.  Our Peterson 50 grinder is the best equipment investment I made. Once the surfaces are clean & flat, the set can be mounted & sealed with any type of gasket. DD 
|
|
| Author: | racinkain [ Wed Aug 17, 2011 12:54 pm ] |
| Post subject: | |
I know on the wagon I used a special gasket I got from the Cox Bros. that was very thick and had no issues with that. Thanks for the NAPA # I will check on getting that. Take care Doug. The manifold is new IM using. |
|
| Author: | 66aCUDA [ Thu Aug 18, 2011 6:29 pm ] |
| Post subject: | |
I carry the thick Aussie Gaskets PM me for pricing. Thanks, Frank |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|