| Slant Six Forum https://slantsix.org/forum/ |
|
| Pertronix plug gap? https://slantsix.org/forum/viewtopic.php?t=46280 |
Page 1 of 1 |
| Author: | JR [ Sat Sep 10, 2011 6:37 pm ] |
| Post subject: | Pertronix plug gap? |
What plug gap are you guys using with your pertronix unit? |
|
| Author: | SlantSixDan [ Sat Sep 10, 2011 7:20 pm ] |
| Post subject: | |
0.035" (stock) worked best on my '64 w/Pertronix. I don't think I'd go larger than 0.040". It's better than points, but it ain't HEI or MSD. |
|
| Author: | 805moparkid [ Sat Sep 10, 2011 7:44 pm ] |
| Post subject: | |
i think mine liked .037... with the ign II and blaster II coil |
|
| Author: | JR [ Sat Sep 10, 2011 7:53 pm ] |
| Post subject: | |
Right now I think it is set at .035 and it runs fine, just seeing if it can run better! I have the HEI/Blaster 2 in my truck and the Pertronix/Blaster 2 in Nikki 66 dart and think that I get a little better spark from the Pertronix. |
|
| Author: | emsvitil [ Sat Sep 10, 2011 11:48 pm ] |
| Post subject: | |
I'm using a pertronix 1 pertronix 3 ohm coil Low resistance spiral metal core plug wires (borq-warner lifetim warranty) and Autolite extended tip 985 plugs. gapped at .044 Runs great, no misfires. |
|
| Author: | JR [ Sun Sep 11, 2011 3:17 pm ] |
| Post subject: | |
I picked up a new cap, B&W wires and a set of NKG "Jeep" plugs (the long ones). I will have Nikki gap them at .037 when she gives the 66 a tune up tomorrow and we will see how it works. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|