Just wondered how you would run this cam? Compression ratio, gears, timing and how you would degree it. Thanks Cory
| Slant Six Forum https://slantsix.org/forum/ |
|
| Cam thoughts. https://slantsix.org/forum/viewtopic.php?t=46593 |
Page 1 of 1 |
| Author: | 75customdart [ Sun Oct 09, 2011 6:54 am ] |
| Post subject: | Cam thoughts. |
Just wondered how you would run this cam? Compression ratio, gears, timing and how you would degree it. Thanks Cory
|
|
| Author: | sandy in BC [ Sun Oct 09, 2011 7:18 am ] |
| Post subject: | |
I run mine with a 5 speed and 3.55 gears, Ground 4 degrees advanced ...installed straight up 9.25:1 CR |
|
| Author: | DusterIdiot [ Sun Oct 09, 2011 9:38 am ] |
| Post subject: | x2 |
Quote: I run mine with a 5 speed and 3.55 gears,
I've run the same cam in two iterations:Ground 4 degrees advanced ...installed straight up 1) A833OD and 3.55 gears, installed straight up (111+4 means the cam is ground with the 4 degrees advance). Worked great for hyperpak, 390 or 600 cfm Holley and 10.3:1 static compression. 2) Currently installed in my other duster at A-230 3spd and 3.55 gears, 10.3:1 SCR, 390cfm Holley, Offy 4 barrel intake. It likes the top end a bit, but is still fine on the bottom end. -D.Idiot |
|
| Author: | 75customdart [ Mon Oct 10, 2011 11:02 am ] |
| Post subject: | |
Thanks for the input guy. Think I'll bring the compression up a little before I put the motor in my dads car. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|