Chinese parts are nothing to Joke about, they are a joke though!
| Slant Six Forum https://slantsix.org/forum/ |
|
| what is a good source for front end boots? https://slantsix.org/forum/viewtopic.php?t=47774 |
Page 1 of 1 |
| Author: | Ed Mullen [ Mon Jan 30, 2012 4:39 pm ] |
| Post subject: | what is a good source for front end boots? |
70 valiant sitting since the 70's. front end has zero wear but rubber is all shot. jimsautoparts.com has a set that works out to like $17/pc. (if I was going to spend that much I'd buy all new Chinese parts, scrap the iron, and just use the new boots on my original rods, joints, arms etc.) |
|
| Author: | Joshie225 [ Mon Jan 30, 2012 5:07 pm ] |
| Post subject: | |
Energy Suspension makes polyurethane dust boots. If you know the sizes you need you're set. http://energysuspension.com/products/Ti ... Boots.html |
|
| Author: | DusterIdiot [ Mon Jan 30, 2012 6:10 pm ] |
| Post subject: | x2 |
They pretty heavy duty compared to what comes with your regular balljoints,etc... I like mine, they haven't split yet! -D.Idiot |
|
| Author: | Ed Mullen [ Mon Jan 30, 2012 6:55 pm ] |
| Post subject: | |
thanks. Autozone sells that brand and seems to catalog them application-specific. |
|
| Author: | SlantSixDan [ Mon Jan 30, 2012 7:23 pm ] |
| Post subject: | Re: what is a good source for front end boots? |
Quote: I'd buy all new Chinese parts
Never a good idea if you can possibly avoid it.
|
|
| Author: | Ed Mullen [ Tue Jan 31, 2012 1:42 pm ] |
| Post subject: | |
Quote: Never a good idea if you can possibly avoid it.
It was a joke, actually.
|
|
| Author: | Danarchy [ Tue Jan 31, 2012 1:51 pm ] |
| Post subject: | |
Chinese parts are nothing to Joke about, they are a joke though!
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|