Hi everyone,

I am replacing my timing chain this week... The old one was pretty slack (pictures to follow).

Should I purchase a degree wheel and a dial indicator and degree my stock camshaft?

- Mac

I would probably not degree a stock rebuild. You can always print a degree wheel from the internet if you were so inclined and put it on some sturdy cardboard.

_________________
11.02 @ 120.56
http://www.youtube.com/watch?v=EAxRmoDgsdY
Chassis dyno
http://www.youtube.com/watch?v=wd6hFGzLJMc

Actually, I have read enough horror stories about replacement timing sets being many degrees off of correct that I think it is actually worth it to degree the cam any time the cam or any timing component is replaced.

_________________
Casually looking for a Clifford hyperpak intake for cheap.

[quote="Reed"]Actually, I have read enough horror stories about replacement timing sets being many degrees off of correct that I think it is actually worth it to degree the cam any time the cam or any timing component is replaced.[quote]
X2...

_________________
There's no such thing as too much cam....only not enough engine!