| Slant Six Forum https://slantsix.org/forum/ |
|
| Degree stock cam? https://slantsix.org/forum/viewtopic.php?t=48241 |
Page 1 of 1 |
| Author: | Slanted Opinion [ Mon Mar 19, 2012 12:06 pm ] |
| Post subject: | Degree stock cam? |
Hi everyone, I am replacing my timing chain this week... The old one was pretty slack (pictures to follow). Should I purchase a degree wheel and a dial indicator and degree my stock camshaft? - Mac |
|
| Author: | Shaker223 [ Mon Mar 19, 2012 12:50 pm ] |
| Post subject: | |
I would probably not degree a stock rebuild. You can always print a degree wheel from the internet if you were so inclined and put it on some sturdy cardboard. |
|
| Author: | Reed [ Mon Mar 19, 2012 12:59 pm ] |
| Post subject: | |
Actually, I have read enough horror stories about replacement timing sets being many degrees off of correct that I think it is actually worth it to degree the cam any time the cam or any timing component is replaced. |
|
| Author: | CNC-Dude [ Mon Mar 19, 2012 1:50 pm ] |
| Post subject: | |
[quote="Reed"]Actually, I have read enough horror stories about replacement timing sets being many degrees off of correct that I think it is actually worth it to degree the cam any time the cam or any timing component is replaced.[quote] X2... |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|