We put them in by going around the pack with a thin feeler gauge to work the lip of the seal under.
If you can't easily push the piston down with your fingers you've got the lip rolled.
| Slant Six Forum https://slantsix.org/forum/ |
|
| 904 rear Clutch Pack Piston Install https://slantsix.org/forum/viewtopic.php?t=48421 |
Page 1 of 1 |
| Author: | Greg Ondayko [ Fri Apr 06, 2012 10:13 am ] |
| Post subject: | 904 rear Clutch Pack Piston Install |
Hello Sages, Any Suggestions on geatting the Rear Piston Reinstalled for the Clutch Pack? I put a New Rubber Seal and Lubed it up - It's tough to get in there.. I do Have a Press to use; I am just afaraid of rolling the lip on the Outer Seal. Greg |
|
| Author: | Fopar [ Fri Apr 06, 2012 10:58 am ] |
| Post subject: | |
A piece of Mylar sheet cut to not quite meet at the ends when installed into the hole you are trying to put the piston/seal into, will act like a tapered ring compressor. Leave enough Mylar in heighth to be able to pull out and don't forget to lube it for the seal to slide on. Richard |
|
| Author: | Greg Ondayko [ Fri Apr 06, 2012 2:32 pm ] |
| Post subject: | |
Great Tip. Thanks Richard. Greg |
|
| Author: | slantzilla [ Sat Apr 07, 2012 5:09 pm ] |
| Post subject: | |
We put them in by going around the pack with a thin feeler gauge to work the lip of the seal under. If you can't easily push the piston down with your fingers you've got the lip rolled.
|
|
| Author: | Greg Ondayko [ Sat Apr 07, 2012 7:03 pm ] |
| Post subject: | |
Thanks Dennis - That too is another way to go about this problem. I was able to install it _ I just used My press and a large Ball joint socket to get it started - Problem was I couldnt get it started square just using my hands alone, then I would roll the seal. Greg |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|