Yes Dennis they do
my wife doesn't like to ride in my Dart 
Richard
| Slant Six Forum https://slantsix.org/forum/ |
|
| 7.25 to 8.25 drive shaft https://slantsix.org/forum/viewtopic.php?t=48988 |
Page 1 of 1 |
| Author: | Lobster1 [ Mon Jun 04, 2012 12:18 pm ] |
| Post subject: | 7.25 to 8.25 drive shaft |
Hi all, I'm ready to install my 8.25 rear and I wondered if anyone know the overall length of the 8.25 drive shaft or the amount I need to shorten from the 7.25 length? Is there a recommended tranny mount for my 62 valiant auto? I have the poly motor mounts, but thinking about not going poly at the trans? But open minded about it... Cheers, Barnaby |
|
| Author: | Fopar [ Mon Jun 04, 2012 12:49 pm ] |
| Post subject: | |
Barnaby, On my Dart I have poly for motor and rubber for trans, so far no problems. Richard |
|
| Author: | Lobster1 [ Mon Jun 04, 2012 6:23 pm ] |
| Post subject: | |
Thanks Richard, I think that is the direction I'll go. I'm doing my best to have it ready for Woodburn... Any thoughts on those drive line measurements? Cheers, BT |
|
| Author: | slantzilla [ Mon Jun 04, 2012 6:30 pm ] |
| Post subject: | |
I had a poly trans mount in my Duster. It transmitted a LOT of vibration into the car. IIRC, you will need to shorten your driveshaft 1.5". I know that is close, but don't remember the exact amount I had mine cut. |
|
| Author: | Fopar [ Mon Jun 04, 2012 6:49 pm ] |
| Post subject: | |
Yes Dennis they do my wife doesn't like to ride in my Dart Richard |
|
| Author: | slantzilla [ Mon Jun 04, 2012 7:22 pm ] |
| Post subject: | |
I had a converter that had a weight issue and it nearly shook the windshield out of the car.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|