| Slant Six Forum https://slantsix.org/forum/ |
|
| Engine Removal Question https://slantsix.org/forum/viewtopic.php?t=49220 |
Page 1 of 1 |
| Author: | e50095 [ Fri Jul 06, 2012 8:02 am ] |
| Post subject: | Engine Removal Question |
Does anyone know the thread size of the bolt holes in the side of the head near the lip of the valve cover? It looks to me like those are the attaching points for the chain in removing the engine with a cherry picker. Might be good to get the carb out of the way though.... thanks... Ken in Pa. 
|
|
| Author: | Doctor Dodge [ Fri Jul 06, 2012 8:15 am ] |
| Post subject: | |
3/8 - 16 unc thread size... Watch-out on 'pinching" the edge of the valve cover with the chain or strap. DD |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|