| Slant Six Forum https://slantsix.org/forum/ |
|
| Steering Coupling Roll Pin Size https://slantsix.org/forum/viewtopic.php?t=50877 |
Page 1 of 1 |
| Author: | Greg Ondayko [ Sun Jan 20, 2013 2:25 pm ] |
| Post subject: | Steering Coupling Roll Pin Size |
What size is the Roll Pin in the Steering Coupling? I would imagine Most Mopar Cars 68-89 RWD's Would be the Same. This is for a 68 Val. Mine split in 2 When I Pounded it out. Looking for a Replacement Now. Greg |
|
| Author: | Romeo Furio [ Sun Jan 20, 2013 4:18 pm ] |
| Post subject: | |
Greg, Can't give you the actual size. But I do know that I got mine from the hardware store. They had a assortment of sizes. I used a cotter pin as a gauge.Then went one size over. |
|
| Author: | Dart270 [ Sun Jan 20, 2013 8:06 pm ] |
| Post subject: | |
I think it is 5/16", but not sure. I had the same experience as Romeo. Lou |
|
| Author: | DusterIdiot [ Sun Jan 20, 2013 8:14 pm ] |
| Post subject: | Yep... |
I just drove that pin out 3 hours ago...it's about a 5/16" as lou said. -D.Idiot |
|
| Author: | Dodge33 [ Thu Jan 24, 2013 6:52 pm ] |
| Post subject: | |
I just checked a rollpin that I removed from a 68 Dart...... and the diameter was about .315 or 5/16" by 1.125 or 1 1/8th inche's in length. Hope this help's everyone. |
|
| Author: | Greg Ondayko [ Mon Jan 28, 2013 7:27 am ] |
| Post subject: | |
Thanks Guys, I just got one at Lowes yesterday. Came in a pack of 2 so I can have a spare! Greg |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|