| Slant Six Forum https://slantsix.org/forum/ |
|
| Copper head gasket source https://slantsix.org/forum/viewtopic.php?t=51216 |
Page 1 of 1 |
| Author: | billdedman [ Sun Feb 24, 2013 4:46 pm ] |
| Post subject: | Copper head gasket source |
Can anyone here direct me to a supplier for a copper head gasket for my +.065"-bore 225? I am going to try to O-Ring the head, I think. If I run 25-pounds of boost like I want to, I don't think the setup we have now will hold. Any information will be appreciated! Bill |
|
| Author: | Will [ Sun Feb 24, 2013 6:46 pm ] |
| Post subject: | |
I use SCE the most. But have used Clark before. http://www.scegaskets.com/ just got a custom one last week. $115 $21 shipping Will |
|
| Author: | billdedman [ Sun Feb 24, 2013 9:23 pm ] |
| Post subject: | |
Thanks, Will. Are the cylinder holes in it round? Some head gaskets aren't. I want to use as a template to mark my head for O-Ring location/cutting, so, it needs to be round for that. Bill |
|
| Author: | CNC-Dude [ Sun Feb 24, 2013 9:48 pm ] |
| Post subject: | |
How big are the diameters of your combustion chambers? |
|
| Author: | Charrlie_S [ Mon Feb 25, 2013 6:07 am ] |
| Post subject: | |
http://clarkcopperheadgaskets.com/cchg/ ... tent/?id=1 |
|
| Author: | billdedman [ Mon Feb 25, 2013 9:44 am ] |
| Post subject: | |
Thanks, Charrlie; I really appreciate the link!!! Bill |
|
| Author: | Charrlie_S [ Mon Feb 25, 2013 4:58 pm ] |
| Post subject: | |
I have talked to them, and I would probably try them, but haven't as yet. So no personal experiance. |
|
| Author: | billdedman [ Mon Feb 25, 2013 9:18 pm ] |
| Post subject: | |
Quote: How big are the diameters of your combustion chambers?
They are un-modified as far as I know, Will, so whatever is stock I guess...
|
|
| Author: | Will [ Thu Feb 28, 2013 3:51 am ] |
| Post subject: | |
Yes, round holes. Will |
|
| Author: | billdedman [ Thu Feb 28, 2013 11:37 am ] |
| Post subject: | |
Will, Is there a significant difference in the SCE gaskets over the Clark units? I will order from one of them, but the Clark gaskets are a lot cheaper. I just wondered why you choose to spend the extra money with SCE. Thanks for any info... Bill |
|
| Author: | billdedman [ Thu Feb 28, 2013 11:43 am ] |
| Post subject: | |
".They are un-modified as far as I know, Will, so whatever is stock I guess..." That was supposed to be directed toward CNC-Dude, not Will. Sorry, CNC-Dude. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|