| Slant Six Forum https://slantsix.org/forum/ |
|
| Torque specs https://slantsix.org/forum/viewtopic.php?t=51770 |
Page 1 of 1 |
| Author: | Eggman63 [ Sat Apr 20, 2013 4:52 am ] |
| Post subject: | Torque specs |
I know I have to adhere to the torque specs for the stock cast iron intake and exhaust manifolds,but what about a Clifford intake and headers?Do I tighten them super tight or do I leave them room for expansion? |
|
| Author: | wjajr [ Sat Apr 20, 2013 7:13 am ] |
| Post subject: | |
I torque my Clifford intake and shorty headers at same as factory set up, and now use the good gaskets by Remflex. ZERO leaks. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|