| Slant Six Forum https://slantsix.org/forum/ |
|
| Rocker arm jam nuts https://slantsix.org/forum/viewtopic.php?t=51872 |
Page 1 of 1 |
| Author: | HyperValiant [ Sat Apr 27, 2013 8:03 am ] |
| Post subject: | Rocker arm jam nuts |
I need to know what size half nut ya'll are using for your rocker arm adjusters.I have 3/8-24 but they seem way too tight.all help is welcome as I am tired of readjusting my valves every time I run over 5000 rpm.Thanks in advance. HyperValiant |
|
| Author: | sandy in BC [ Sat Apr 27, 2013 8:36 am ] |
| Post subject: | |
I use 3/8NF half nuts.... |
|
| Author: | bwhitejr [ Sat Apr 27, 2013 12:02 pm ] |
| Post subject: | half nuts |
I believe they are 40 threads to the inch. |
|
| Author: | sandy in BC [ Sat Apr 27, 2013 12:16 pm ] |
| Post subject: | |
3/8 UNF = 24 threads per inch |
|
| Author: | Dart270 [ Mon Apr 29, 2013 3:21 am ] |
| Post subject: | |
Yes, 3/8 - 24. They will be tight because the rocker screws are made to be tight. You can run a die over them if you really want them looser. Lou |
|
| Author: | HyperValiant [ Mon Apr 29, 2013 10:22 am ] |
| Post subject: | |
Thanks fellas,now maybe I can keep a good lash on this engine. I know that I should probably get shorter push rods but this is the last season for this engine and probably the last 170 Ill build for a while. Thanks again HyperValiant |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|