| Slant Six Forum https://slantsix.org/forum/ |
|
| Speedo Cable into Transmission - Am I missing a part? https://slantsix.org/forum/viewtopic.php?t=52092 |
Page 1 of 1 |
| Author: | nagosnell [ Thu May 16, 2013 10:07 am ] |
| Post subject: | Speedo Cable into Transmission - Am I missing a part? |
I'm just about finished with getting my Belvedere back on the road but I still have yet another strange question. I think I'm missing a part that connects the speedometer cable to the 3-speed transmission. I found a wire tie hanging on the cable that I believe I had attached some sort of bracket as not to lose it...that worked well. The only problem is that I can't remember what it looked like and how it attached. Below is a "professional" drawing of the area on the transmission where the cable and gear go into one hole and a bolt goes in another. I am guessing that there was a bracket there that fit over the cable gear and was held in by the bolt. Can anyone confirm this and perhaps take a pic of this area of their transmission? If I know what the bracket looks like, I can fabricate my own. Thanks.
|
|
| Author: | DusterIdiot [ Thu May 16, 2013 12:47 pm ] |
| Post subject: | Should have... |
You should have a round housing to go into the tranny, and a "claw' that holds the housing in place and in some cases are indexed based on tooth count. -D.Idiot |
|
| Author: | Fopar [ Thu May 16, 2013 1:16 pm ] |
| Post subject: | |
![]() Dirty but it is a squared flat metal peice trans is from 63 dart. Richard |
|
| Author: | nagosnell [ Fri May 17, 2013 10:20 am ] |
| Post subject: | |
Perfect! Just what I needed. Thanks for the help. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|