Slant Six Forum https://slantsix.org/forum/ |
|
o ring block https://slantsix.org/forum/viewtopic.php?t=52463 |
Page 1 of 1 |
Author: | terrylittlejohn [ Sun Jun 23, 2013 6:32 pm ] |
Post subject: | o ring block |
is there any number of times that O-rings can be retorqued with out having to change them. I used an iskey kit that had copper wire and this is the third retorque , the wire seem low in the grooves? I read somewhere that mig wire was better than the copper wire that came with the kit. |
Author: | CNC-Dude [ Mon Jun 24, 2013 12:15 am ] |
Post subject: | |
I think it would be a good opportunity to upgrade to a harder wire. A copper wire is soft just like the gasket and isn't going to be as effective at "biting" into the gasket to provide a better seal. |
Author: | terrylittlejohn [ Mon Jun 24, 2013 6:09 am ] |
Post subject: | |
thanks, have you heard that solid mig wire was a better choice? |
Author: | CNC-Dude [ Mon Jun 24, 2013 10:43 am ] |
Post subject: | |
Never heard of using mig wire, but I suppose its better than copper wire. I have always used precision stainless wire(music wire actually) as it fits the o-ring groove for a tighter fit and won't pop out of the groove as easily. |
Author: | terrylittlejohn [ Mon Jun 24, 2013 12:03 pm ] |
Post subject: | |
you mean piano or guitar string wirer? |
Author: | CNC-Dude [ Mon Jun 24, 2013 3:07 pm ] |
Post subject: | |
Yeah, piano wire. |
Page 1 of 1 | All times are UTC-07:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |