| Slant Six Forum https://slantsix.org/forum/ |
|
| factory cruise control options https://slantsix.org/forum/viewtopic.php?t=52860 |
Page 1 of 1 |
| Author: | Greg Ondayko [ Fri Jul 26, 2013 8:54 pm ] |
| Post subject: | factory cruise control options |
Hello sages... I want to install cruise in one of my cars.. I have all the parts to do the install, but I want to know if ma mopar evr put cruise in a car with a stick? all the ones I have evr seen and noticed are cruise with automatics. can a Cruise unit be safely installed In a stick car? if so are there any additional considerations than in an auto car? thanks, Greg |
|
| Author: | Reed [ Fri Jul 26, 2013 10:34 pm ] |
| Post subject: | |
Engine runaway when the clutch is disengaged would be one worry. I would recommend installing some kind of interrupt switch on the clutch, but this would most likely require resetting the cruise every time you shifted. |
|
| Author: | emsvitil [ Sat Jul 27, 2013 2:51 am ] |
| Post subject: | |
You could have a rev limiter on the ignition to avoid a complete runaway......... |
|
| Author: | Charrlie_S [ Sat Jul 27, 2013 4:55 am ] |
| Post subject: | |
I have aftermarket cruise control on my Toyota PU. 5 speed stick, and have installed many over the years. All of the ones I have installed, use a clutch safety switch. They also had circitry in the module that sences, ign pulses, and will disengage the cruise, if the RPM increases at too fast a rate. |
|
| Author: | DadTruck [ Mon Jul 29, 2013 6:02 am ] |
| Post subject: | |
Greg I am adding cruse control to the 83 D-150,, a833... did a some internet searches on forums patronized by car audio installers, asked them what system they prefer. The cruse controls from Rostra Precision got a lot of recommendations. And that is what I went with. http://www.rostra.com/universal-afterma ... rostra.php The kits are available on E bay,,but one of the installers recommended buying the kit direct from Brandon Distributing, (877-402-3944) as they have a tech line if there are questions on the install. I did that also. Concerning using the Rostra cruise control with a manual tranny,, there are two options to control engine over speed if the cruse is active and one shifts into neutral. The kit has an option for a clutch safety switch, that will shut off the cruse if the clutch is engaged or built into the kit is a wire that T's into the tachometer feed wire from the coil. It is suppost to sense if engine RPM's increase rapidly and disengage the unit. I wired in the tach feed line. I have the kit installed, the instructions are very detailed, actually pretty good, There is a diagnoistic test,, that I have ran,, says everything is hooked up correctly ,, as I make progress on the D-150, I will get to try it.. |
|
| Author: | slantvaliant [ Wed Jul 31, 2013 5:35 pm ] |
| Post subject: | |
My '93 Volvo 850 5-speed has cruise control. It uses a small motor to pull a vacuum to hold the speed. Pushing either the brake or the clutch pedal disengages the cruise control. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|