| Slant Six Forum https://slantsix.org/forum/ |
|
| Bypass the ballast how to... https://slantsix.org/forum/viewtopic.php?t=53400 |
Page 1 of 1 |
| Author: | SlantedTrucker [ Mon Sep 23, 2013 5:00 am ] |
| Post subject: | Bypass the ballast how to... |
I'm going to switch to a Pertronix 3ohm coil so I can bypass the ballast resister. My question is: what is the proper way to put these wires together? This is a dual or 4 terminal resister. |
|
| Author: | Aggressive Ted [ Thu Sep 26, 2013 12:37 pm ] |
| Post subject: | |
Solder them! Then use heat shrink over them. |
|
| Author: | SlantedTrucker [ Sat Sep 28, 2013 4:11 am ] |
| Post subject: | |
Thanks Ted, thats what I'll do. |
|
| Author: | josekh7 [ Thu Oct 10, 2013 5:39 pm ] |
| Post subject: | |
im doing the same thing to my ignitor 1 should i but any fuse or anything to protect the hotcoil? |
|
| Author: | carlherrnstein [ Fri Oct 11, 2013 6:13 am ] |
| Post subject: | |
That circuit already has a fuse in it. |
|
| Author: | Aggressive Ted [ Sat Oct 12, 2013 11:49 am ] |
| Post subject: | |
Quote: im doing the same thing to my ignitor 1 should i but any fuse or anything to protect the hotcoil?
Do not put a fuse on the coil. That will cause lots of problems with poor voltage to the coil from the fuse glowing causing a huge drop in voltage.Also many Ignitor 1 and 11's die from low voltage and lack of cooling. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|