| Slant Six Forum https://slantsix.org/forum/ |
|
| Holley 2280 carb spacer https://slantsix.org/forum/viewtopic.php?t=53591 |
Page 1 of 1 |
| Author: | DartDude [ Mon Oct 14, 2013 8:31 pm ] |
| Post subject: | Holley 2280 carb spacer |
is there a such thing ? I do need the "gasket" that goes in between the carb and the manifold |
|
| Author: | carlherrnstein [ Tue Oct 15, 2013 4:43 am ] |
| Post subject: | |
I doubt you need a carb spacer unless there is a interference issue with the throttle linkage or some other part. As I remember the Holley 2280 is a replacement carb for the Carter BBD on some 318s I would guess that a spacer and gasket(s) from that application would work. |
|
| Author: | Reed [ Tue Oct 15, 2013 6:10 am ] |
| Post subject: | Re: Holley 2280 carb spacer |
Quote: is there a such thing ?
I have never seen one, but that doesn't mean you can't make one. The issue will be hood clearance if you go too tall.Quote: I do need the "gasket" that goes in between the carb and the manifold
Yes, you need the thick one so the linkage will clear the intake manifold.http://www.slantsix.org/articles/supersix/article.htm |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|