| Slant Six Forum https://slantsix.org/forum/ |
|
| Campbell Enterprises Flexplates https://slantsix.org/forum/viewtopic.php?t=53840 |
Page 1 of 1 |
| Author: | ceej [ Wed Nov 13, 2013 1:39 am ] |
| Post subject: | Campbell Enterprises Flexplates |
Been looking at SFI options. Found the 130 tooth heavy one adapting to the GM trans. Probably work well for my application. It's for the V8 pattern, so a small mod would be needed. http://www.campbellenterprises.com/jw_p ... xplate.htm There is also one at the bottom of the page that would work for the 904/727. Just random surfing for parts. Anybody else got some sources for this stuff? CJ |
|
| Author: | Sam Powell [ Wed Nov 13, 2013 7:30 pm ] |
| Post subject: | |
Ceej, What mods are needed to bolt one of these to a slant crank? What tooth number does a slant require? Thanks. Sam |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|