| Slant Six Forum https://slantsix.org/forum/ |
|
| ball & trunion swap https://slantsix.org/forum/viewtopic.php?t=54286 |
Page 1 of 1 |
| Author: | AHamilton [ Fri Jan 10, 2014 1:58 pm ] |
| Post subject: | ball & trunion swap |
I remember seeing at one time there is a conversion from the ball and trunion to a u joint. I looked through the search engine with no successful results. Can anyone help me with my search. I am swapping an 8 3/4 into my 63search valiant convt. |
|
| Author: | Rick Covalt [ Fri Jan 10, 2014 2:07 pm ] |
| Post subject: | |
The search function on here is hit or miss for me! I think the link below will help some! http://www.earlycuda.org/tech/ujoint.htm |
|
| Author: | 64ragtop [ Wed Jan 15, 2014 10:46 pm ] |
| Post subject: | |
That's a great article, but if no local driveshaft shop, I can recommend from my personal experience, these folks: http://www.driveshaftspecialist.com/Lef ... ssics.html BC |
|
| Author: | Charrlie_S [ Thu Jan 16, 2014 9:57 am ] |
| Post subject: | |
I can recommend this place: http://www.raneys.com/ They built my driveshaft (the one in this link http://www.earlycuda.org/tech/ujoint.htm) about 10 years ago. Can't get as good a price now, but I stopped by today, and got a quote of between $270 and $300 plus shipping. All new driveshaft balanced and ready to bolt in. If you are interesed talk to Scott VanBeek, and tell him Charlie Schmid sent you. 1-888-888-6225 or scottv@raneys.com |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|