Slant *        6        Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to help support the Slant Six Forum!
It is currently Sat Nov 21, 2026 11:11 am

All times are UTC-08:00




Post new topic  Reply to topic  [ 5 posts ] 
Author Message
PostPosted: Sun Apr 27, 2014 6:41 pm 
Offline
Supercharged

Joined: Sun Jun 04, 2006 4:53 pm
Posts: 4295
Location: Gaithersburg MD
Car Model:
This is what I found on line. Are these always right, or are there variants? Is the slant 904 the same. I kind of assume they are talking V-8 here.

Transmission
Gears
1st 2nd 3rd 4th
727 2.45 1.45 1.00
904 2.70 1.54 1.00
518 2.45 1.45 1.00 0.69
500 2.74 1.54 1.00 0.69

_________________
Image


Top
   
 Post subject:
PostPosted: Mon Apr 28, 2014 4:27 am 
Offline
SL6 Racer & Moderator
User avatar

Joined: Sat Oct 19, 2002 12:06 pm
Posts: 9094
Location: Silver Springs, Fl.
Car Model:
If I remember correctly, the 904 had gear ratios of: 2.45-1.45-1.00 in the early years. Somewhere in the 1970's they went to the "wide" ratio low 1st gear, of: 2.74-1.54-1.00

_________________
Charrlie_S
65 Valiant 100 2dr post 170 turbo
66 Valiant Signet 170 nitrous
64 Valiant Signet
64 Valiant 4dr 170
64 Valiant 4dr 225


Top
   
 Post subject:
PostPosted: Mon Apr 28, 2014 4:57 am 
Offline
Supercharged

Joined: Sun Jun 04, 2006 4:53 pm
Posts: 4295
Location: Gaithersburg MD
Car Model:
Thanks Charlie. I have worked up a chart on Excell that shows rpm vs speed in all gears of both versions, with the four most popular rears, and with an overdrive trans. As soon as I can figure out how to get it posted on photobucket I will post it in another new thread discussing rear end ratios.

Sam

_________________
Image


Top
   
 Post subject: There used to be....
PostPosted: Mon Apr 28, 2014 5:48 am 
Offline
Board Sponsor
User avatar

Joined: Tue Oct 29, 2002 8:27 pm
Posts: 9714
Location: Salem, OR
Car Model:
There used to be a couple of nice spreadsheets floating around on one of the other mopar boards that you could plug the tranny ratios into, your rear gear ratio, your tire size...then it would spit out the rpms for you and the speedo gear tooth count as well....Pretty accurate for working up drivetrain options, the automatic chart was nice enough to calc in a factor for convertor slippage as well.

FYI.

-D.Idiot


Top
   
 Post subject:
PostPosted: Mon Apr 28, 2014 6:14 am 
Offline
Supercharged

Joined: Sun Jun 04, 2006 4:53 pm
Posts: 4295
Location: Gaithersburg MD
Car Model:
Thanks DI. I went ahead and worked up my own based on current performance. It did not take long. My trans has lock up Torque Convertor, which takes out the slippage issue. Although the projected mileage with the 904 OD is about 1.5 mpg lower than actual measured mileage with the old T-5 which had .79 OD as opposed to the .78 of the GV unit.

I am eager to read comments on reactions to the various ratios folks have experience with.

Sam

_________________
Image


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 5 posts ] 

All times are UTC-08:00


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited