| Slant Six Forum https://slantsix.org/forum/ |
|
| carburator installation https://slantsix.org/forum/viewtopic.php?t=55601 |
Page 1 of 1 |
| Author: | josekh7 [ Sat Jun 14, 2014 10:01 am ] |
| Post subject: | carburator installation |
Hey guys fairly easy question is there a recomended torque specs to bolt down a carb i have a 2280..Reason being every time i uninstall the carb and i see the mounting gasket i can see the vacuum crevices stamped into the gasket..so i might be over torquing? |
|
| Author: | DadTruck [ Sun Jun 15, 2014 4:51 am ] |
| Post subject: | |
It is possible to over torque , but seeing the imprint of the carb base details is normal. I run the stud nuts down firmly with hand tools, recheck after a few heat cycles. The better carb base gaskets have compression limiters in the mounting holes, on those you can't over squeeze the gaskets. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|