| Slant Six Forum https://slantsix.org/forum/ |
|
| Mounting a degree wheel https://slantsix.org/forum/viewtopic.php?t=55613 |
Page 1 of 1 |
| Author: | 1930 [ Sun Jun 15, 2014 11:35 am ] |
| Post subject: | Mounting a degree wheel |
Id like to know how you guys are mounting your degree wheel, is there a special fixture that I can buy? My biggest issue is getting the degree wheel tight since the end of the crank is recessed into the pulley about 2-3 inches. What are you guys using? Id like something that has a quick action release so I can turn the wheel if need be without an issue. I have seen on You-Tube these fast releases but not for Slant engines. Thanks |
|
| Author: | 1930 [ Sun Jun 15, 2014 12:10 pm ] |
| Post subject: | |
http://slantsix.org/forum/viewtopic.php ... pener+bolt |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|