Slant Six Forum
https://slantsix.org/forum/

hard start after running for long periods
https://slantsix.org/forum/viewtopic.php?t=55824
Page 1 of 1

Author:  John Deville [ Mon Jul 21, 2014 6:16 am ]
Post subject:  hard start after running for long periods

Hey guys,
Havent had any problems in a long while. But now I am having a hard start after long periods of run time. If the motor has time to cool, it does start. Replaced cap and rotor, and have a Pertronix. 1361A. In place, also, have Pertronix flame thrower 3.0 ohm coil, all was new two years ago. Could the coil go bad so soon?

Also sometime ago I read here I should run through the valve train at around ten thousand miles. Which is where I am at. And am going to do. But would that cause a hard start after long run times. Suggestions? / thanks much in advance

Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/