| Slant Six Forum https://slantsix.org/forum/ |
|
| Rebuild Suggestions for the 6 Bolt Oil Pump https://slantsix.org/forum/viewtopic.php?t=55867 |
Page 1 of 1 |
| Author: | nm9stheham [ Sun Jul 27, 2014 1:10 pm ] |
| Post subject: | Rebuild Suggestions for the 6 Bolt Oil Pump |
I can't yet find any parts for the older 6 bolt pumps, like what is original on my '62 /6. Is there any source for these parts any more? If not, does anyone one know if I could get a newer 5 bolt Melling and take out the thicker pump gears and just have them machined thinner for my older case? And is there any source for the gears? Tnx! Mark B. |
|
| Author: | Joshie225 [ Sun Jul 27, 2014 6:45 pm ] |
| Post subject: | |
Kanter lists oil pump repair kits. http://www.kanter.com/p24-mon.html#mo2 |
|
| Author: | nm9stheham [ Sun Jul 27, 2014 6:59 pm ] |
| Post subject: | |
Saw that.....I might call. With 3 thicknesses of gears, it is hard to know what would be in a kit without specifics. Anyone have a later melling gear set handy to measure the dimensions? |
|
| Author: | xjarhead [ Sun Jul 27, 2014 7:30 pm ] |
| Post subject: | |
Pm Doc and see if he has a pump he modifies them too. http://www.slantsix.org/forum/viewtopic.php?t=29492 Dave |
|
| Author: | nm9stheham [ Tue Jul 29, 2014 11:08 am ] |
| Post subject: | |
Done, tnx! |
|
| Author: | Doctor Dodge [ Tue Jul 29, 2014 11:13 am ] |
| Post subject: | |
The 3 sizes are 5/8, 7/8 and 1 inch. I can build a "blueprinted" oil pump using any of the sizes listed and install a case hardened (heat treated) drive gear. Send me a PM for details. DD |
|
| Author: | nm9stheham [ Tue Jul 29, 2014 3:07 pm ] |
| Post subject: | |
Seding PM; thanks! |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|