| Slant Six Forum https://slantsix.org/forum/ |
|
| Valiant Body Panels https://slantsix.org/forum/viewtopic.php?t=57534 |
Page 1 of 1 |
| Author: | polara pat [ Fri Apr 17, 2015 7:23 pm ] |
| Post subject: | Valiant Body Panels |
I'm pretty sure that this is a lost cause but I figure there's no harm in asking. The lower driver's side quarter on our '64 is perforated and in need of some new steel. Oh did I mention that it's a wagon? I know, good luck right. I'd really like to get some fresh paint down on the ol' wagon this Spring. It deserves it. |
|
| Author: | polara pat [ Sat May 09, 2015 4:35 pm ] |
| Post subject: | |
Apparently the mob has spoken. Looks like I'll be doing some panel bashing. |
|
| Author: | SlantSixDan [ Sat May 09, 2015 4:57 pm ] |
| Post subject: | |
SKU 401 and 402 here. But the shipping will probably sting! |
|
| Author: | polara pat [ Sun May 10, 2015 9:39 am ] |
| Post subject: | |
Quote: SKU 401 and 402 here. But the shipping will probably sting!
Right on!! Thanks SSD. As long as I can get them to the border then it's not too much trouble to pick them up. In truth, it's really only the driver's side rear quarter where the exhaust exits that is really bad. This is the first car that I ever painted and body work wasn't even considered at the time. Mostly because I had no knowledge about body work or paint for that matter.
|
|
| Author: | polara pat [ Sun May 10, 2015 9:53 am ] |
| Post subject: | |
Haha, I just realized that this was from Australia. Carry on. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|