| Slant Six Forum https://slantsix.org/forum/ |
|
| Machining Out Crankshaft Counterbore https://slantsix.org/forum/viewtopic.php?t=58578 |
Page 1 of 1 |
| Author: | smittyp5 [ Thu Oct 22, 2015 3:17 pm ] |
| Post subject: | Machining Out Crankshaft Counterbore |
I am swapping a blown 68 for a running 66. Is the machining out of the crankshaft counterbore an acceptable modification to make this work? |
|
| Author: | slantzilla [ Thu Oct 22, 2015 6:26 pm ] |
| Post subject: | |
Yes, or you can have a converter made with a small snout. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|