| Slant Six Forum https://slantsix.org/forum/ |
|
| Intake/Exhaust Slide Room https://slantsix.org/forum/viewtopic.php?t=5864 |
Page 1 of 1 |
| Author: | Daddiojoe [ Wed May 28, 2003 9:06 am ] |
| Post subject: | Intake/Exhaust Slide Room |
 I read in the article about manifold installation that the assembly slides in relation to the engine block.Just how much does it slide? I'm upgrading to the super six for my 71 D100 and the front of the exhaust manifold bumps up against the airconditioner compressor. Thanks for your help, Joe |
|
| Author: | Doc [ Wed May 28, 2003 10:01 am ] |
| Post subject: | |
I would say about 1/8 of an inch per end (.125) from dead cold to red hot. Sounds like you may need to do a little grinding work. DD |
|
| Author: | Daddiojoe [ Thu May 29, 2003 8:11 am ] |
| Post subject: | Thanks |
Yeah, that's what I was thinking. Good to have it confirmed by an expert. Joe |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|