| Slant Six Forum https://slantsix.org/forum/ |
|
| 65 tranny shift bushings https://slantsix.org/forum/viewtopic.php?t=59029 |
Page 1 of 1 |
| Author: | dookdart [ Wed Jan 27, 2016 4:45 am ] |
| Post subject: | 65 tranny shift bushings |
I was looking for rubber bushings for the 3 spd. manual trans on our 65 D100 project. This is where the lower shift rods go into the trans. shift lever arms. Brewers and Passon said they were not available  HOWEVER!!! I was able to source nearly identical bushings that will work!!!! I've got extras if anyone needs some! MIke |
|
| Author: | dookdart [ Thu Jan 28, 2016 7:27 pm ] |
| Post subject: | |
I found some grommets. rare size, had to buy a bunch of them. So...I'll sell the rest; $6.50 per pair of two including shipping. I need to look under our 67 Dart, 3 spd. column. I'm not sure if its the same bushings or not. we'll see...... Also: bushings seem unique to the A745 shift arms. |
|
| Author: | Charrlie_S [ Fri Jan 29, 2016 5:30 am ] |
| Post subject: | |
Hey, Mike. I'll take a pair. Send me a PM with your paypal addy. |
|
| Author: | dookdart [ Mon Feb 08, 2016 5:45 pm ] |
| Post subject: | |
They fit the A-745 manual transmission. The Dart 3 spd. A903 has smaller bushings. UPdated: 2/10- I cant' figure out USPS. I went to 2 different offices....2 different prices. wTf? .. |
|
| Author: | dookdart [ Wed Feb 10, 2016 4:15 am ] |
| Post subject: | |
Got it Charlie. packaged, ready to go today (need to get to post office). MIke |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|