Referencing this pic:
The small square hole in the center is to clear the oil pickup tube.
What is the large square hole for?
| Slant Six Forum https://slantsix.org/forum/ |
|
| Windage tray question? https://slantsix.org/forum/viewtopic.php?t=59600 |
Page 1 of 1 |
| Author: | Badvert65 [ Thu May 05, 2016 12:05 pm ] |
| Post subject: | Windage tray question? |
Referencing this pic: The small square hole in the center is to clear the oil pickup tube. What is the large square hole for? |
|
| Author: | Badvert65 [ Thu May 05, 2016 12:14 pm ] |
| Post subject: | |
I guess, the next question is, did I put the dang thing on correctly? I am assuming a clockwise engine rotation (looking at the engine from the front). 
|
|
| Author: | slantzilla [ Thu May 05, 2016 12:37 pm ] |
| Post subject: | |
One hole is the pickup, other is for dipstick. |
|
| Author: | Badvert65 [ Fri May 06, 2016 12:15 pm ] |
| Post subject: | |
Does the engine rotate clockwise when looking at it from the front? I am fairly certain it does, but it's just something I never paid enough attention to. |
|
| Author: | Joshie225 [ Fri May 06, 2016 1:01 pm ] |
| Post subject: | |
Yes. That's why it unloads the right rear tire. |
|
| Author: | Badvert65 [ Fri May 06, 2016 1:15 pm ] |
| Post subject: | |
Maybe with YOUR slant... |
|
| Author: | Joshie225 [ Fri May 06, 2016 1:36 pm ] |
| Post subject: | |
Fixed. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|