| Slant Six Forum https://slantsix.org/forum/ |
|
| crank spacer https://slantsix.org/forum/viewtopic.php?t=59687 |
Page 1 of 1 |
| Author: | terrylittlejohn [ Wed May 25, 2016 6:55 am ] |
| Post subject: | crank spacer |
anybody know of a machine shop that does blower pulley spacers? I had all my pulleys and spacer done by a guy who has a shop in California but his ebay shop is closed and I can`t contact him. I have the romac damper, I need to space out for the inset on the front of the damper. |
|
| Author: | jcc [ Wed May 25, 2016 8:22 am ] |
| Post subject: | |
I recently got a 1/2" alum spacer front hub from Jones Racing products. I needed a spacer for my 60-2 EFI reluctor wheel. They make a number of useful items, The romac already had 3 3/8" threaded mounting holes, that almost fit a chevy hub pattern. I made it fit. However not sure I would go that route on a blower app, and there was no register. I bet however Jones would do something custom, and until you ask, you never know. http://www.jonesracingproducts.com/ |
|
| Author: | Badvert65 [ Wed May 25, 2016 8:51 am ] |
| Post subject: | |
I think these are actually for a chevy engine, but I think they still fit the slant six balancer pattern. They have them in different thicknesses. http://www.ebay.com/itm/261857858516?_t ... EBIDX%3AIT |
|
| Author: | Dart270 [ Wed May 25, 2016 11:29 am ] |
| Post subject: | |
Nice info folks. Thanks, Lou |
|
| Author: | terrylittlejohn [ Wed May 25, 2016 2:08 pm ] |
| Post subject: | |
just talking to jones racing, great guy I have sent some pictures of the romac damper. he seem to think it`s no problem, thanks jcc. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|