Slant Six Forum
https://slantsix.org/forum/

Edelbrock 1405 question??????
https://slantsix.org/forum/viewtopic.php?t=59862		 Page 1 of 1
Author:  slantzilla [ Mon Jul 04, 2016 12:29 pm ]
Post subject:  Edelbrock 1405 question??????
Was tunning on Bill's 1405 today trying to clear up a random miss/droppee cylinders condition. Everything looked fine until I started doing the carb spray check for vacuum leaks. Left side primary throttle shaft bore is worn out. You can literally move the shaft around 1/8" and cause the issue at will. Is there a repair kit for this or will we just sell it as is for parts?

Thanks! :D
Author:  ceej [ Mon Jul 04, 2016 10:17 pm ]
Post subject: 
It's probably a better financial decision to get another one from a swap meet that is in good shape.
Not a lot of rebush info out there. Some Ebay stuff, but who knows there. Edelbrock and Carter throttle shafts do run a tad loose, but that sounds excessive! :lol:

I've been fortunate with the old Carter Fopar gifted me some years back. It's in awesome shape! :D

CJ
Author:  slantzilla [ Mon Jul 04, 2016 10:37 pm ]
Post subject: 
Thanks Ceej, but a better decision has already been made. He's ordering a Holley tomorrow. :lol:

I'll have him dump this one on E-bag for parts. :D
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/