| Slant Six Forum https://slantsix.org/forum/ |
|
| New clutch hydraulic line https://slantsix.org/forum/viewtopic.php?t=60270 |
Page 1 of 1 |
| Author: | the mothership [ Tue Oct 04, 2016 10:26 pm ] |
| Post subject: | New clutch hydraulic line |
Hey everyone - I'm midway through a brake line rebuild, using 3/16" copper/nickel, and am realizing I'm going to need to order another roll of the stuff. I'll have a ton left over, and right there next to the brake line is a rusty ancient clutch cylinder and lines... SO, my question: the existing clutch line appears to be 1/4", would it be a bad idea to use 3/16" there? If I DO get 1/4", is it bad to mix 1/4" and 3/16" in the brake system? Thanks muchly - Jason |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|