These rods have been discontinued and I was planning on using them with a nice block that has some work already done. Molner said if he was to get 8 orders he would produce theme again but it has to be at least 8 sets. They are not best sellers. I believe a cast crack which is lighter would whirl around faster thou not a strong as forged but I decided to go with cast.

If anyone is interested please contact molner. If anyone has a set they want to sell PLEASE let me know, I'd buy them right away.

any thoughts please post. Mike

_________________
I has a 225 with overdrive....my plate is a vetrains plate from MAASACHUSETTS it is
198 S I might want to put a 198 overbored and stroke to come up with 213 cubic inches!!!!!!!!

There are at least a couple sets listed on eBay right now.

_________________
--> Check out my FI Turbo build <--
--> And the race truck build project <--
--> The Diesel Corvette <--

Those are all for forged crank engines.

_________________
There's no such thing as too much cam....only not enough engine!

Not these:
http://www.ebay.com/itm/MOLNAR-TECHNOLO ... 84&vxp=mtr

Or these:
http://www.ebay.com/itm/MOLNAR-TECHNOLO ... 84&vxp=mtr

_________________
--> Check out my FI Turbo build <--
--> And the race truck build project <--
--> The Diesel Corvette <--

Must have been newly added. When he posted this about a while back there were only the forged crank rods on there. Both say last set, so he'd better jump on them. It'd probably be hard to get 8 more people committed to building a cast crank engine to have another run of them made.

_________________
There's no such thing as too much cam....only not enough engine!