| Slant Six Forum https://slantsix.org/forum/ |
|
| Spring retainers https://slantsix.org/forum/viewtopic.php?t=60405 |
Page 1 of 1 |
| Author: | Docmcg [ Wed Nov 02, 2016 7:30 pm ] |
| Post subject: | Spring retainers |
I'm in the middle of my rebuild and need some info. I bought oversized valves from SI valves and need retainers and locks. SI says they don't carry them. The intake valves are a 2 groove lock and the exhaust are 4 grooves. Can anyone tell me where to get retainers and locks for these valves? Thanks, Doc. |
|
| Author: | Joshie225 [ Fri Nov 04, 2016 9:09 am ] |
| Post subject: | |
Those valves should use stock style valve locks. Comp Cams has Chrysler multi-groove locks. Ignore the picture. https://www.summitracing.com/parts/cca-606-16/overview/ Retainers are based on the spring dimensions, but these are correct for a 340 type spring (large OD single spring with flat damper): https://www.summitracing.com/parts/cca-744-12 If you have smaller springs or certain dual springs you'll need different retainers. |
|
| Author: | DusterIdiot [ Fri Nov 04, 2016 5:15 pm ] |
| Post subject: | x2 |
Quote: Those valves should use stock style valve locks.
Yes the SI valves I have I reused the locks from the stock valves.
|
|
| Author: | Docmcg [ Fri Nov 04, 2016 6:29 pm ] |
| Post subject: | |
Thanks for the info guys. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|