Slant Six Forum
https://slantsix.org/forum/

CAST Molnar K1 rods
https://slantsix.org/forum/viewtopic.php?t=60410		 Page 1 of 1
Author:  mike8x7 [ Thu Nov 03, 2016 2:08 pm ]
Post subject:  CAST Molnar K1 rods
:cry: These rods have been discontinued and I was planning on using them with a nice block that has some work already done. :D Molner said if he was to get 8 orders he would produce theme again but it has to be at least 8 sets. They are not best sellers. I believe a cast crack which is lighter would whirl around faster thou not a strong as forged but I decided to go with cast.

If anyone is interested please contact molner. If anyone has a set they want to sell PLEASE let me know, I'd buy them right away.

any thoughts please post. Mike
Author:  ProCycle [ Thu Nov 03, 2016 2:17 pm ]
Post subject: 
There are at least a couple sets listed on eBay right now.
Author:  CNC-Dude [ Fri Nov 04, 2016 2:05 pm ]
Post subject: 
Those are all for forged crank engines.
Author:  ProCycle [ Fri Nov 04, 2016 3:00 pm ]
Post subject: 
Not these:
http://www.ebay.com/itm/MOLNAR-TECHNOLO ... 84&vxp=mtr

Or these:
http://www.ebay.com/itm/MOLNAR-TECHNOLO ... 84&vxp=mtr
Author:  CNC-Dude [ Fri Nov 04, 2016 3:29 pm ]
Post subject: 
Must have been newly added. When he posted this about a while back there were only the forged crank rods on there. Both say last set, so he'd better jump on them. It'd probably be hard to get 8 more people committed to building a cast crank engine to have another run of them made.
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/