Harley pistons? You were serious? and Sportster made it even Funnier!
| Slant Six Forum https://slantsix.org/forum/ |
|
| Is there a source for any of the wiseco 3.504's https://slantsix.org/forum/viewtopic.php?t=60509 |
Page 1 of 1 |
| Author: | Greg Ondayko [ Mon Nov 28, 2016 7:34 pm ] |
| Post subject: | Is there a source for any of the wiseco 3.504's |
Are there any 3.504 pistons available any more? Just curious. Thanks, Greg |
|
| Author: | emsvitil [ Mon Nov 28, 2016 8:21 pm ] |
| Post subject: | |
Harley 1200cc sportster engines are 3.5" bore.... With oversize pistons you can get a little more. Not sure about the pin diameter or height................ |
|
| Author: | Greg Ondayko [ Wed Nov 30, 2016 2:59 pm ] |
| Post subject: | |
Thanks... not what i waned to hear but its better than nothing. Greg |
|
| Author: | Danarchy [ Wed Nov 30, 2016 4:06 pm ] |
| Post subject: | |
Harley pistons? You were serious? and Sportster made it even Funnier!
|
|
| Author: | emsvitil [ Thu Dec 01, 2016 4:43 am ] |
| Post subject: | |
Just found this: http://www.jayracing.com/mobile/wiseco- ... -7556.html |
|
| Author: | Greg Ondayko [ Thu Dec 01, 2016 6:42 am ] |
| Post subject: | |
cool, Thank you. Greg |
|
| Author: | slantzilla [ Thu Dec 01, 2016 9:21 am ] |
| Post subject: | |
Quote: Harley pistons? You were serious? and Sportster made it even Funnier!
I think Seymour did a motor with Harley pistons. I IRC, there is a Corvair piston that works too. 
|
|
| Author: | Exner Geek [ Fri Dec 02, 2016 6:55 am ] |
| Post subject: | |
I used 3 7/16" Corvair pistons from TRW but the only source of .010 over rings so you could file the gap was Harley Davidson. You can still get .060 over Corvair pistons which would be 3.4975" from Clarks Corvair parts. |
|
| Author: | Matt Cramer [ Mon Dec 05, 2016 9:14 am ] |
| Post subject: | |
These days you can get pistons available in virtually any size you want at a reasonable price. For example, JE Pistons has their custom sizing order form here: http://www.jepistons.com/Articles/2weekstandard.aspx Often it's something like $10 per piston extra for a custom size. Unbelievably cheap. |
|
| Author: | slantzilla [ Mon Dec 05, 2016 6:49 pm ] |
| Post subject: | |
Ross broke a set of 3.500" customs off in my ass. They were anything but cheap. 
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|