Congrats!!
Now, about that 2 piece timing cover with built in cam stop???
| Slant Six Forum https://slantsix.org/forum/ |
|
| I am featured in a CAD/CAM software article.... https://slantsix.org/forum/viewtopic.php?t=61267 |
Page 1 of 1 |
| Author: | CNC-Dude [ Sat Jun 17, 2017 12:07 pm ] |
| Post subject: | I am featured in a CAD/CAM software article.... |
I was recently asked by my CAD/CAM software company to be the subject of an article they were compiling for their marketing department. Not bad, 2 magazine articles in a month for me, 3 if you count one being another online version. Hope you enjoy! http://bobcad.com/machine-shop-reaches- ... obcad-cam/ |
|
| Author: | Reed [ Sat Jun 17, 2017 1:50 pm ] |
| Post subject: | |
Hey! Congratulations! It is nice when your hard work gets appreciated. Looks like some of those diagrams and parts might be slant related? |
|
| Author: | sandy in BC [ Sat Jun 17, 2017 4:32 pm ] |
| Post subject: | |
Congrats! Recognition is 2nd only to remuneration. |
|
| Author: | CNC-Dude [ Sun Jun 18, 2017 9:21 am ] |
| Post subject: | |
Quote: Hey! Congratulations! It is nice when your hard work gets appreciated. Looks like some of those diagrams and parts might be slant related?
Yes they are, thanks! I've had quite a few magazine articles featuring my products over the years, but its always rewarding to see them recognized and valued by respected people in the industry for what they can benefit the enthusiasts.
|
|
| Author: | Rick Covalt [ Sun Jun 18, 2017 11:58 am ] |
| Post subject: | |
Congrats!! Now, about that 2 piece timing cover with built in cam stop???
|
|
| Author: | CNC-Dude [ Wed Jun 21, 2017 12:52 pm ] |
| Post subject: | |
Rick, I think I am going to change my thoughts on the timing cover design. My initial intention was to make a solid profiled piece that bolts to the block and have a thin cover that included the front seal be removable. But Martin brought up a valid option with the design some of the Argentine aftermarket timing covers have. So I may opt to create one that only the portion directly in front of the cam removes, while leaving the area with the front seal in place, or I may make both styles. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|