| Slant Six Forum https://slantsix.org/forum/ |
|
| Torque plate / hone plate available https://slantsix.org/forum/viewtopic.php?t=61905 |
Page 1 of 1 |
| Author: | boot laces [ Fri Feb 02, 2018 1:33 pm ] |
| Post subject: | Torque plate / hone plate available |
I have a torque / hone plate available for a small fee. I'm on the west side of Michigan, by Ludington. If anyone on this side of the state is doing a bore job and feels a plate would be beneficial, get in touch with me. About the plate ; 2.375" thick, bores are 3.51" dia., and there are 14 hardened spacers around 1.135" thick which gets the stock head bolts to proper head install depth. I also have a felpro head gasket which was used for my bore job and we can use it again so that you would not waste a new one. |
|
| Author: | limedust70 [ Tue Feb 06, 2018 7:07 pm ] |
| Post subject: | Re: Torque plate / hone plate available |
Interested in selling? |
|
| Author: | boot laces [ Thu Feb 08, 2018 12:02 pm ] |
| Post subject: | Re: Torque plate / hone plate available |
No, I have more build projects and there's a lot of time and $ wrapped up in it. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|